Using The Answering System; Setting Up Your Answering System - Uniden DECT2180 Series User Manual

Using the Answering System

Setting Up Your Answering System

You can set up your answering system from any handset.
To...
Record your
personal
outgoing
message or
greeting
Switch
between the
pre-recorded
greeting &
your own
greeting
Delete your
greeting
Ans. Setup menu options
You can change the answering system options from any handset.
Just open the menu and select Ans. Setup.
Security Code
Ring Time

Follow these steps
Your greeting can be between 2 seconds and 30 seconds
long. If you don't record an outgoing message, the system
uses a pre-recorded greeting: Hello, no one is available to
take your call. Please leave a message after the tone.
1. Press
MESSAGES/MUTE
until the system finishes its announcements, or press
to skip them.
(STOP)
2. Press .
8
3. Wait for the system to say "Record greeting," then begin
speaking.
4. When you're finished, press
system plays back your new greeting.
5. To keep this greeting, press
step 2.
1. Press
MESSAGES/MUTE
until the system finishes its announcements, or press
to skip them.
(STOP)
2. Press . The system plays back the greeting it is currently
6
using.
3. Press again to switch greetings.
6
1. Switch to your personal greeting following the steps above.
2. While the system is playing back your greeting, press
Enter a 2-digit PIN so you can access your answering
system from any touch-tone phone (see page 21).
Set the number of rings (2, 4, or 6) before the answering
system answers the phone. Choose Toll Saver (TS) to
have the system pick up after 2 rings if you have new
messages or after 4 rings if you don't.
to access the answering system. Wait
to stop recording. The
8
. To re-record it, go back to
END
to access the answering system. Wait
5
5
.
4