Attaching The Belt Clip - Uniden DCX400 User Manual

Changing from Tone to Pulse Dialing
Phones can communicate with the telephone network in two ways:
tone (DTMF) or pulse dialing. If you know your phone company uses
pulse dialing or the test call for line 1 did not work, follow these steps:
1. With the phone in standby, press
2. Use or
UP DOWN
3. Your phone prompts you to select a line and Line 1 is highlighted.
Press OK .
4. Use or
UP DOWN
5. Highlight Pulse, then press
tone. Try making another test call using line 1.
If your test call on line 2 did not connect, follow the same
process, but in step 3, press
.
OK
If you use pulse dialing and you need to send DTMF tones during a
call (if you're using an automated response system, for example),
press to temporarily switch to tone dialing. When the call ends, the
phone automatically returns to pulse dialing mode.

Attaching the Belt Clip

Line up the holes on each side of the handset. Insert the belt clip into
the holes on each side of the handset. Press down until it clicks.
To remove the belt clip, pull either side of the belt clip to release the
tabs from the holes.
6
MENU
to highlight Global Setup, then press
to highlight Dial Mode, then press
OK . The phone sounds a confirmation
to highlight Line 2, then press
DOWN
.
OK .
OK .