Quick Reference Maintenance Chart - Harman Absolute43-C Owner's Manual

B. Quick Reference Maintenance Chart
Frequency Cleaning Procedure
Daily
Scrape Burn pot
Empty Ash Pan
Weekly
Clean the Glass
Scrape & Vacuum Heat Exchanger
Brush & vacuum the distribution fan
Inspect Hopper lid gasket for
Monthly
damage
Clean Igniter
Stove MUST be turned off, cold and unplugged from power supply for Yearly Cleaning.
Brush & vacuum the combustion fan
and venting/exhaust path
Yearly Inspect door gasket
4
Brush & vacuum venting system
* A flue brush of appropriate size and length may need to be purchased for proper maintenance.
1. Protective gloves will help prevent skin abrasion while working on steel surfaces.
2. Frequency of cleaning depends largely on fuel type. Lower quality pellets require most frequent cleaning.
3. Flame resistant gloves will help protect your skin from potential contact with heat or flames.
4. Yearly cleaning is also known as a Total Clean. This requires completing all the Daily, Weekly, Monthly and Yearly
maintenance mentioned. This should be done before you begin burning the unit each heating season.
12
Wear flame resistant gloves
Wear protective gloves.
Put ashes into a steel non-
combustible container with tight
fitting lid outside.
Stove must be turned off and cold.
Stove must be turned off and cold.
Stove must be turned off, cold and
unplugged from power supply.
Stove must be turned off, cold and
unplugged from power supply.
Wear protective gloves.
Put ashes into a steel non-
combustible container with tight
fitting lid outside.
Wear protective gloves.
Put ashes into a steel non-
combustible container with tight
fitting lid outside.
Wear protective gloves.
Put ashes into a steel non-
combustible container with tight
fitting lid outside.
Harman® • Absolute43-C Owner's Manual_R9 • 2018 -___ • 06/20
Safety Measures
3
1
1
1
1
Tips
Vigorous, strong scraping specifically
near neck of burn pot. Scrape every
time you add pellets or at least every
3 bags of fuel.
2
Unit does not need to be turned off.
Reduce to low burn during removal.
Use provided scraper. Scrape back
and sides of firebox.
Use provided paint brush. This
should be done approximately every
25 bags.
2
Replace gasketing if frays, tears or
other visible damage to gasket. This
should be done approximately every
50 bags.
2
Use provided paint brush. Vacuum
loose ash from around igniter and
inside burn pot.
Use provided paint brush to brush
fan blades. *Use flue brush to clean
venting being careful not to damage
the ESP.
2
Replace gasketing if frays, tears or
other visible damage to gasket.
3-90-00772C