Changing The Dial Mode; Installing The Belt Clip - Uniden DCT7085 Series Owner's Manual

2. Check to make sure the battery is fully charged. (If you don't see the "battery full" icon, check to make sure the
battery is properly connected).
3. Change the dial mode (instructions below).

Changing the Dial Mode

Your phone can communicate with the telephone network in two different ways: tone dialing or pulse dialing. These
days, most phone networks use a method called tone dialing, so your phone comes programmed for tone dialing. If
your phone company uses pulse dialing, you will need to change your phone's dial mode. If you don't get a dial tone
or can't connect to the telephone network, please follow the steps below to modify your phone's settings:
1, Press [menu/clear]. Select the GLOBAL SETUP menu, and then the
DIAL MODE submenu.
2. Scroll [ ] to select PULSE.
[ /
3. Press select
If you ever need to change the dial mode back to tone dialing, follow the same procedure, but select TONE in step 2.

Installing the Belt Clip

Line up the holes on each side of the handset. To attach the belt
clip, insert into the holes on each side of the handset. Press down
until it clicks.
To remove the belt clip, pull either side of the belt clip to release
the tabs from the holes.
]
. You will hear a confirmation tone.
16