Test The Connection; Set Up The Accessory Handset(S) - Uniden CEZAI2998 User Manual

Test the Connection

Pick up the corded handset from the base. You should hear a dial tone
and the display on the base should say Talk. When you get a dial tone,
make a quick test call.
If...
the display says Check Tel Line
or you don't hear a dial tone
you keep hearing a dial tone
there's a lot of noise or static
Changing from Tone to Pulse Dialing
Phones can communicate with the telephone network in two different
ways: tone (DTMF) or pulse dialing. If you know your phone company uses
pulse dialing or you can't make your test call, follow these steps:
) With the phone in standby, press
) Use or
up DOWN
) Use or
up DOWN
) Highlight Pulse, then press
confirmation tone. Try making another test call.
If you use pulse dialing and you need to send DTMF tones during a call (if
you're using an automated response system, for example), press
temporarily switch to tone dialing. When the call ends, the phone
automatically returns to pulse dialing mode.

Set Up the Accessory Handset(s)

If your phone came packaged with accessory handsets, follow the steps
below to get your cordless handsets ready for use.
Install the battery
) Unpack all handsets, battery packs,
and battery covers. If any
handset has the battery
cover already attached,
press in on the notch and
slide the cover down and
off.
to highlight Global Setup, then press
to highlight Dial mode, then press
seLeCT/meNu
Try...
checking the connection between the
base and the phone jack.
changing to pulse dialing (see below).
see page 28 for tips on avoiding
interference.
.
seLeCT/meNu
. The phone sounds a
seLeCT/meNu
.
seLeCT/meNu
to
.