GETTING STARTED
Battery Removal and Installation
1. Make sure the unit is turned Off.
2. Locate the batter y cover on the
bottom of the race car. Use a coin or
screwdriver to loosen the screw and
open the battery cover.
3. Remove old batteries by pulling up on
one side of each battery.
4. Install 2 new AAA (AM-4/LR03) batteries following the diagram
inside the battery box. (The use of new alkaline batteries is
recommended for maximum performance.)
5. Replace the battery cover and tighten the screw to secure.
BATTERY NOTICE
•
Use new alkaline batteries for maximum performance
•
Use only batteries of the same or equivalent type as recommended
•
Do not mix different types of batteries: alkaline, standard (carbon-
zinc) or rechargeable, or new and used batteries
•
Do not use damaged batteries
•
Insert batteries with the correct polarity
•
Do not short-circuit the battery terminals
•
Remove exhausted batteries from the toy
•
Remove batteries during long periods of non-use
•
Do not dispose of batteries in fire
•
Do not charge non-rechargeable batteries
•
Remove rechargeable batteries from the toy before charging
(if removable)
•
Rechargeable batteries are only to be charged under adult
supervision
528400 IM .indd 4
4
09/06/2019 9:10:14