KTM 125 SX 2018 Setup Instructions page 7

Info
Make sure the cables and wiring are positioned cor-
rectly.
–
Position the handlebar clamp.
–
Mount screws
–
First bolt the handlebar clamp with screws
higher side of the handlebar supports so that both parts touch.
–
Tighten screws
Guideline
Screw, handlebar
clamp
–
Position the controls on the right half of the handlebar.
K00938-10
–
Position the controls on the left half of the handlebar.
–
Mount cable tie(s).
–
Mount the fuel tank breather.
–
Install the front wheel. (
–
Install front fender. (
–
Install the start number plate. (
K00616-10
–
Mount the handlebar cushion.
K00617-10
3
but do not tighten yet.
3
evenly.
M8 20 Nm (14.8 lbf ft)
p. 9)
p. 10)
p. 10)
2 SETUP
3
onto the longer,
5