KTM 125 SX 2018 Setup Instructions page 11

3.4 Installing the front wheel
Warning
Danger of accidents Oil or grease on the brake discs reduces the braking effect.
–
Always keep the brake discs free of oil and grease.
–
Clean the brake discs with brake cleaner when necessary.
Info
Grooves are milled into the side of the upper end of the
fork legs. The second milled groove (from the top) must
be flush with the top edge of the upper triple clamp.
The air suspension is located in the left fork leg. The
pressure and rebound damping is located in the right
fork leg.
–
Tighten screws
Guideline
Screw, top triple
clamp
–
Tighten screws
Guideline
Screw, bottom triple
clamp
F00011-11
–
Position the brake caliper. Mount and tighten screws
Guideline
Screw, front
brake caliper
–
Position the brake line and clamp. Mount and tighten
5
screws .
K00462-11
Finishing work
–
Install the front wheel. (
–
Check the wheel bearing for damage and wear.
» If the wheel bearing is damaged or worn:
–
Change front wheel bearing.
–
Clean and grease shaft seal rings
of the spacers.
Long-life grease (
–
Insert the spacers.
–
Clean and grease the wheel spindle.
H00935-10
Long-life grease (
2
.
M8 17 Nm (12.5 lbf ft)
3 .
M8 12 Nm (8.9 lbf ft)
M8 25 Nm (18.4 lbf ft)
p. 9)
1
and contact surface
p. 17)
p. 17)
3 WORK
4
.
Loctite ® 243™
A
9