Connect The Charger; Installing The Battery Pack - Uniden 2305 Owner's Manual

UU881BH(WDECT2305) ENG

Connect the Charger

1 Connect the AC adapter
to the DC IN 9V jack
and to a standard AC
wall outlet.
2 Set the charger on a
desk or tabletop, and
place the handset in
the charger with the
keypad facing forward.
3 Make sure the charge LED illuminates. If the LED does not
illuminate, check to see that the AC adapter is plugged in
and that the handset makes good contact with the charger
charging contacts.
• Use only the supplied AC adapter. Do not use any other
AC adapter.
• Place the charger close to the AC outlet so that you can
unplug the AC adapter easily.

Installing the Battery Pack

1 Press down on the battery cover
release and slide the cover down
until it comes off.
2 Plug the battery pack connector
(red & black wires) into the jack
inside the battery compartment.
(The connector notches fit into the
grooves of the jack only one-way.)
Match the wire colors to the
polarity label in the battery
compartment, and push the
connector in until you hear a click.
5/10/04 3:57 PM Page 3
AC adaptor
(supplied)
To AC outlet
To DC IN 9V
Black Red
Wire Wire
[ 3 ]