Table of Contents
Advertisement
17.Trial fit the wing mount in the fuselage, sand to fit if
necessary.
18.Before gluing the mount in the place, sand the
area in fuselage that will contact the plate with 200
grit sandpaper. This will provide a better glue
bond. Glue the plate in place either by thick
instant glue or epoxy.
19.Locate the two wires and join the wing by inserting
the wires to the wing halves.
Hint: The wires have 2 degreed dihedral prebent
into them, make sure the two wires are up right
before join the wing halves.
ASSEMBLY / FUSELAGE
20.Place the main wing on the fuselage with the wing
halves jointed CLOSELY.
Use masking tape to tape to hold together. Use the
holes on the wing as the guide to make drill marks.
Drill 5mm(3/16") holes where you marked.
21.Remove the wing and screw the 6/32 wing bolt all
the way in so the blind nut is fixed in the wing
mount.
6
5mm 3/16"
Hide quick links:
Advertisement
Table of Contents
