Table of Contents
Advertisement
SAFETY INFORMATION
W A R N I N G
Read all safety warnings and all instructions. Failure to follow the warnings and instructions may result in electric shock,
fire, and/or serious injuries.
Save all warnings and instructions for future reference.
• Use only identical manufacturer's replacement parts and accessories. Use of any other parts may create a hazard or
cause product damage.
• Always wear safety glasses with side shields marked to comply with ANSI Z87.1. Everyday glasses have only impact
resistant lenses. They are NOT safety glasses. Following this rule will reduce the risk of eye injury. Use face mask if
operating in dusty work spaces.
• Avoid Dangerous Environment — Don't expose power tools to damp or wet conditions. Water entering a power tool will
increase the risk of electric shock.
• Do not use in rain.
• Keep all bystanders, children, and pets at least 50 ft. away.
• Do not use the power tools for any job except that for which it is intended.
• Avoid Unintentional Starting – Do not carry appliance with fingers on the switch. Be sure the battery is removed while
transporting.
• Do not operate the equipment while barefoot or when wearing sandals or similar lightweight footwear. Wear protective
footwear that will protect your feet and improve your footing on slippery surfaces.
• Don't overreach - Keep proper footing and balance at all times.
• Stay alert - Watch what you are doing. Use common sense. Do not operate this unit when you are tired, ill or under the
influence of alcohol, drugs or medication.
• Always store idle power tools indoors - When not in use, power tools should be stored indoors in a dry place, out of reach
of children.
• Power tool maintenance – Replace tine if cracked, chipped, or damaged in any way. Be sure the tine is properly installed
and securely fastened. Keep tine edge sharp and clean for best performance and to reduce the risk of injury. Follow
instructions for lubricating and changing accessories. Keep handles dry, clean, and free from oil and grease. Failure to do
so can cause serious injury.
• Check Damaged Parts – Before further use of the appliance, a guard or other part that is damaged should be carefully
checked to determine that it will operate properly and perform its intended function. Check for alignment of moving parts,
binding of moving parts, breakage of parts, damaged mountings, and any other condition that may affect its operation.
A guard or other part that is damaged should be properly repaired or replaced by an authorized service center unless
indicated elsewhere in this manual.
• Do not charge or operate cordless tools in damp or wet locations or in the rain. Following this rule will reduce the risk of
electric shock.
• Remove or disconnect battery before servicing, cleaning or removing material from the gardening appliance.
• Do not dispose of the batteries in a fire. The cells may explode. Check with local codes for possible special disposal
instructions.
• Do not open or mutilate the batteries. Released electrolyte is corrosive and may cause damage to the eyes or skin. It may
be toxic if swallowed.
• Exercise care in handling batteries in order not to short the battery with conducting materials such as rings, bracelets,
and keys. The battery or conductor may overheat and cause burns.
• Dress Properly – Do not wear loose clothing or jewelry. They can be caught in moving parts. Use of rubber gloves and
substantial footwear is recommended when working outdoors. Wear protective hair covering to contain long hair.
• Do not add unnecessary force to your power tool – It will do the job better and with less likelihood of a risk of injury at the
rate for which it was designed.
• Recharge only with the charger specified by the manufacturer. A charger that is suitable for one type of battery pack may
create a risk of fire when used with another battery pack.
3
Advertisement
Table of Contents
