LG ProBeam Owner's Manual page 118

[No Signal Image]
(Q. Settings)
You can turn on or off the image displayed when there is no signal.
• [On]
The default image is displayed if there is no signal.
•
[Off]
The [No Signal] message is displayed if there is no signal.
[Auto Power]
(Q. Settings)
Makes the projector turn on automatically when the power cord is connected to the
projector.
• [On]
When the power cord is connected to the projector, it turns on automatically.
•
[Off]
When the power cord is connected to the projector, it goes into standby mode.
[High Altitude]
(Q. Settings)
If the projector is used at an altitude higher than 1200 meters (3937.0 feet), turn this
on.
Otherwise, the projector may overheat or its protection function may be activated. If
this happens, turn the projector off and then on again after waiting for several minutes.
• Some models may not be supported.
[General] [Additional Settings]
[General] [Additional Settings]
[General] [Additional Settings]
67
[No Signal Image]
[Auto Power]
[High Altitude]