Table of Contents
Advertisement
•
Insert a flat-head screw driver or similar object into the battery door latch and gently pry
upward to release the battery door from the base.
•
Insert the batteries inside the battery compartment as shown on the diagram.
•
Snap the battery compartment door back into place.
NOTE
If the low battery icon appears in the display, you need to replace the batteries. It is important that
you replace them as soon as possible to maintain unit operation when electrical power is off. As a
precaution, you may want to write down any stored information you do not want erased.
IMPORTANT
If you are not going to use the telephone for more than 30 days, remove the batteries because
they can leak and damage the unit.
3. Plug the power supply cord into the power jack on the back of the base and the other end into
an electrical outlet.
Caution: To reduce risk of personal injury, fire, or damage use only the base power
adaptor supplied. This power adaptor is intended to be correctly orientated in a vertical
or floor mount position.
4. Connect the telephone line cords:
If you are connecting to two 1-line phone jacks with two phone cords:
You can use the two included 1-line phone cords to connect the phone lines to the jacks in the
back of your phone.
Line 2
If you are connecting to one 2-line phone jack with one phone cord:
If you have Line 1 and Line 2 wired into one wall jack in your home or office, you can use one
of the supplied telephone line cords to connect from the wall jack to the Line 1+2 jack on the
back of the phone as shown below.
Line 1
Line 1 + 2
11
Hide quick links:
Advertisement
Table of Contents
