Connect Supply Lines / Inlet Hoses To Machine; Connect Supply Lines / Inlet Hoses To Water Supply - EdgeStar CWD1550BL-1 Owner's Manual

NOTE: There may be
residual moisture in
the drum of your new
combo washer/dryer.
EdgeStar runs every
unit through a series of
performance tests
during the quality
control process.
EdgeStar Combo Washer/Dryer

Connect supply lines / inlet hoses to machine

Connect both water inlet hoses to the back of the Combo Washer/Dryer
as indicated in the figure below. The hot and cold water input ports are
color coded, red for hot and blue for cold. Use adjustable pliers to tighten
firmly.

Connect supply lines / inlet hoses to water supply

Connect each of the water inlet hoses to the corresponding water supply
valve (hot or cold) and tighten securely by turning the connector
clockwise. Use adjustable pliers to tighten firmly.
IMPORTANT: Check for leaks! Open both water supply valves and ensure
that all 4 connections are sealed tightly. If not, close the supply valves
and repeat the steps to connect inlet hoses and ensure that you have
threaded the hose connections properly. Once you are satisfied that the
hoses have been connected properly, please close both water supply
valves and continue the installation process.
NOTE: This appliance will heat water to the appropriate temperature if a
hot water source is unavailable. Increased energy consumption will occur.
8