Receiving "Pager Code" Calls From A Remote Station (Standby Operation); Notification Of A Call From A Remote Station By The Bell Function - Yaesu FTM-300DR Advance Manual

9. Rotate the DIAL knob to select the TX CODE 1 of the
codes from 01 to 50.
10. Press the DIAL knob or the [BACK] key.
11. Rotate the DIAL knob to select [TX CODE 2] then
press the DIAL knob.
12. Rotate the DIAL knob to select the TX CODE 2 of the
codes from 01 to 50.
The same code cannot be used for TX CODE 1 and
TX CODE 2.
13. Press the [DISP] key or the PTT switch to save the
setting and return to normal operation.
14. Press the PTT switch to transmit a call to the specific
station.
• The reverse combination works as the same code, that is "05 47" is the same as "47 05".
• If the same code is specified for all individuals, all the individuals can be called at the same
time.
• The default code is "05 47".
• When receiving the codes, the sound of the tones may be heard intermittently.

Receiving "Pager Code" calls from a Remote Station (Standby Operation)

When the Pager function is activated, the audio of received calls with a corresponding
Pager Code is heard.
Furthermore, when the Bell function (see below) is activated, the bell rings when receiv-
ing calls from the other station.

Notification of a Call from a Remote Station by the Bell Function

The Bell may be set to sound an Alert when a call from another station containing a
cor-responding tone, DCS or pager code is received.
1. Press and hold the [F(SETUP)] key  [SIGNALING]  [4 BELL RINGER]
2. Rotate the DIAL knob to select the desired number of
times (1 - 8 times or continuous) the Bell rings.
1 time / 3 times / 5 times / 8 times / CONTINUOUS
If the setting is "CONTINUOUS", the bell keeps
sounding until an operation is made.
3. Press the [DISP] key or the PTT switch to save the setting and return to normal
operation, The " " icon appears on the display.
13
SIGNALING
OFF
1 AUTO DIALER
2 PAGER CODE
3 PR FREQUENCY
4 BELL RINGER
>