Troy-Bilt 70 Operator's Manual page 9

Attaching The Bag
7. Grasp bag handle with one hand and slide locking rod
on mounting bracket with other hand toward engine.
Use the end of mounting bracket as leverage when
sliding the locking rod.
a. Slip bag over the rim of the discharge opening and
release locking rod to secure bag in place. See
Figure 3-7.
b. Snap bag clip to the top of the lower handle.
c. Place the lower straps on the bag over the top
of lower handle, hooking them on the studs. See
Figure 3-7.
NOTE: The bag/chute switch button attached to the
mounting bracket must be fully depressed by the tip of
front tab on bag handle when securing the bag or engine
will not start.
Attaching The Blower Chute
(If Equipped)
NOTE: The bag must be removed before installing the
blower chute.
8. a. Grasp blower chute with one hand and slide locking
rod on mounting bracket with other hand toward
engine. Use the end of mounting bracket as lever-
age when sliding the locking rod. See Figure 3-8.
b. Slip blower chute over rim of discharge opening
and release locking rod to secure chute in place.
c. Raise the nozzle height to the highest setting when
using the blower chute. Refer to nozzle height
adjustment in the OPERATING YOUR CHIPPER/
SHREDDER VACUUM section.
NOTE: The bag/chute switch button attached to the
mounting bracket must be fully depressed by the tip of
front tab on the blower chute or engine will not start.
A
Figure 3-7
Figure 3-8
9
B
Setting Up
Chipper
C
Shredder
Vacuum
NOTE: The bag must
be removed before
installing the blower
chute.
3
Your