Unfolding & Adjusting Handles; Fixing The Cable - Murray 2691585 Assembly And Owner's Manual

Unfolding & Adjusting the Handles
For 37cm Model, Refer to Figure 1, 2 & 3.
• Lead the lower handle through the hole in the cable retain hang and hook on it.
• Slide the two fixing blocks to the end of lower handle.
• Insert the quick release lock into the tube and handle seat. Screw the bolt in and
clamp it to fix the lower handle.
• Fit the upper handle and lower handle together with quick release clamp. You can
rotate release lock to adjust the tightness of lock.
For 32cm Model, Refer to Figure 4 & 5.
• Locate the lower handle into deck as shown in Fig.- and tighten it with the screws.
• Fit the upper handle and lower handle together using the bolt and knob.

Fixing the cable

NOTE: Refer to Figure 6 & 7.
• Restraint cable clips (9) onto the cable leading from the switchbox to the motor and fix
each against the lower and upper handles.
• When connecting to power supply, double the extension cord about a foot from the end
and hook the loop over the cable retain hang (16).
ASSEMBLY PROCEDURES
Fig. 1
Fig. 4
Fig. 6
Fig. 2
WARNING
Do not operate if handles are
incorrectly installed.
Fig. 5
WARNING
Make sure the cable is secured
using the cable clips prior to
connecting the plug to the
mains outlet.
Make sure to uncoil the
extension cord completely
before using.
Fig. 7
2
1
Fig. 3
6