Fitting The Auger; Starting / Stopping The Engine - Stihl BT 131 Instruction Manual

Fitting the Auger

Shut off the engine and engage the
N
auger brake – see "Auger Brake".
Put the machine down.
N
2
1
3
Pull the retaining pin (1) out of the
N
auger's shank.
Push the auger (2) onto the drilling
N
spindle so that the holes (3) line up.
Push the retaining pin into the hole.
N
Spring clip on the retaining pin must
N
fit snugly around the auger's shank.
BT 131
Starting / Stopping the
Engine
Engaging the Auger Brake
A
3
Move the activating lever to
N
position A . Auger brake is engaged
and auger is blocked.
Controls
1 Throttle trigger lockout
2 Throttle trigger
3
1
2
3 Stop switch with Run and Stop
positions. Depress the stop switch
(...) to switch off the ignition – see
"Function of Stop Switch and
Ignition System".
Function of Stop Switch and Ignition
System
The stop switch is normally in the Run
position, i.e. when it is not depressed:
The ignition is switched on – the engine
is ready to start. Operate the stop switch
to switch off the ignition. The ignition is
switched on again automatically after
the engine stops.
Starting the Engine
Press the manual fuel pump
N
bulb (9) at least five times – even if
the bulb is already filled with fuel.
English
11