Auger Brake - Stihl BT 131 Instruction Manual

English

Auger Brake

Engaging the Auger Brake
A
Move the activating lever to
N
position A .
when starting
–
at idling speed
–
to unwind a trapped auger
–
If the auger snags on an obstacle in the
hole (e.g. roots or stones) the machine
will begin to turn counterclockwise – the
activating lever is pressed against the
operator's thigh and thus engages the
auger brake.
10
Disengaging the Auger Brake
B
Move the activating lever to
N
position B
Checking Operation of Auger Brake
The auger brake is subject to normal
wear and tear. Regularly check that it is
operating properly before you start work
and after releasing a trapped auger.
Before starting work and after releasing
a trapped auger
With the engine running at idle
N
speed, engage the auger brake and
then open the throttle wide for no
more than 3 seconds – the auger
must not rotate.
If the auger brake fails, have it repaired
immediately by your dealer – STIHL
recommends that this work be
performed by a STIHL servicing dealer.
BT 131