Assembly - Troy-Bilt Thoroughbred 654J Operator's Manual

Troy-bilt real-tine tiller operator's manual

Hide thumbs Also See for Thoroughbred 654J:

Table of Contents

SECTION 2: ASSEMBLING THE TILLER

NOTE:

All references to the RIGHT or LEFT side of the

tiller are observed from operator's position.

Tools Needed for Assembly

•

9/16" Wrench

•

7/16" Wrench or Nutdriver (Control Box)

•

Two 1/2" Wrenches

•

Phillips Screwdriver

Attaching the Handle

NOTE:

Before beginning assembly, unfasten the cables

and lay them across the back of the tiller. Having an

assistant will ease completion of the following steps.

1. Remove the lower handle hardware (two hex screws,

two lock washers, one carriage screw & one handle

crank) from the tiller's frame.

2. Position the handle mount bracket over the tiller

frame.

3. Align the handle mount bracket's rear holes (either

upper or lower, depending on the operator's height)

with the holes in the tiller frame. Insert the carriage

bolt through the holes from right to left and secure it

with the handle crank.

4. Align the handle mount bracket's front holes with the

holes in the tiller frame. Using a 9/16" wrench, secure

the handle mount bracket to the tiller frame with the

hex screws and lock washers removed earlier.

(Handle Mount Bracket)

(Threaded Cable Adjuster)

(Control Box)

Table of Contents