Removing The Cylinder Frame; Installing The Embroidery Frame Holder - Brother PRCL1 User Manual

■ Removing the cylinder frame

After finishing sewing, remove the cylinder frame,
then the fabric.
a
Remove the cylinder frame from the cylinder
frame driver.
Press down the two holders at the base of the
cylinder frame with both thumbs, and then
pull the cylinder frame off of the machine, as
shown in the illustration.
a
1
Driver holders
Note
● When removing the cylinder frame, be
careful not to hit the presser foot or any
nearby machine parts.
b
Remove the clips, and then pull the fabric
toward you to release stabilizer from the
stabilizer holder.
a
1
Clips
12
Installing the embroidery
frame holder
After removing the needle plate spacer and the
cylinder frame driver, re-attach the embroidery
frame holder.
a
b
a
Remove the needle plate spacer.
1
Needle plate spacer
Note
● Remove the needle plate spacer from the
top. It may be damaged if it is pulled toward
you with force.
Loosen the two lower thumb screws.
a
1
Thumb screw
a
a