Brother PRCL1 User Manual page 12

Cylinder frame
Table of Contents

Advertisement

Available languages

Available languages

b
Position the stabilizer into the stabilizer
holder on the cylinder frame.
1
Stabilizer holder
• There is a stabilizer holder on the left side
and on the right side. On one side, insert the
end of the stabilizer between the stabilizer
holder and the cylinder frame. Wrap the top
of the cylinder frame and extend the
stabilizer to the stabilizer holder on the
opposite side. Straighten and firmly position
the stabilizer.
• Secure the stabilizer so that it does not
extend past the dotted line in the direction of
the arrow shown in the illustration above.
• Depending on the type of fabric used, it may
be necessary to use two to three layers of
stabilizer for successful embroidering.
• It is recommended to use stabilizer
130 mm x 250 mm (5" x 7") in size. If the
stabilizer is too large, it may be difficult to
hoop the fabric.
c
Align the center of the design placement
with the notch in the cylinder frame
mounting jig.
b
1
Center of design placement
2
Notch in cylinder frame mounting jig
Memo
● Before positioning the fabric and stabilizer
in the frame, mark the center of the design
placement with a chalk pencil.
10
d
a
e
1
• Repeat steps
● When securing the fabric with the clips, the
a
Pull the ends of the fabric out from the
center to remove any slack. Be careful not
to shift the center of the design placement.
Use the clips to secure the fabric and
stabilizer.
a
Clips
d
e
and
on the other side to
remove any slack and secure the fabric with
the clips.
Note
handles (rings) should be pointing
downward.

Advertisement

Table of Contents
loading

Table of Contents