Lubrication Chart - Troy-Bilt 13074-GTX 18 Owner's/Operator's Manual

NOTE: A hand type grease gun is
recommended when greasing your unit.
High pressure type grease guns could
cause damage to the fittings and bearing
seals. Lubricate all linkages, levers and
pins not equipped with grease fittings,
with an oil can once each week; more
often depending on operating conditions.
3
1
Frequency
Item
Engine First 5
1
Crankcase hours
25 hours
Hydrostatic Check each
2
use. Change
Transmission
when oil is
discolored,
dirty or after
100 hours
Front
3
25 hours or
Wheel Spindles
end of season
Front Axle 25 hours or
4
Pivot end of season
25 hours or
Lift Shaft
5
end of season
Maintenance (continued)

Lubrication Chart

4
5
Lubricate from
both sides.
Type of Lubrication
See engine manual
Lubrication intervals vary
with operating conditions
and type of oil used
1-Speed Units: Use SAE
20 wt. Part No. 737-0335
2-Speed Units: Use
Part No. 737-0333
(Benzoil Gear Hydro Oil)
Alternate Oils - Mobil 423,
Amoco 1000 or Texaco TDH
Multi-purpose grease
Multi-purpose grease
Multi-purpose oil
FRONT
View from
under tractor.
2
Amt. Required
See engine manual
Fill to within safety
operating zone
As required
As required
As required
25