Schwinn A.C. Power Owner's Manual page 15

Hide thumbs Also See for A.C. Power:

Service manual (37 pages)

Assembly manual (7 pages)

Owner's manual (36 pages)

Table Of Contents

Clean and seal frame

Lubricate horizontal and vertical seat sliders

Inspect welds for any signs of cracking

Calibration

Perform 4iii Calibration

Cleaning

Wipe down and clean Bike and Frame

Clean Console

1 - Verify that pedal bolts are tight after the first 10 hours of use and every 100 hours of use thereafter. Pedal-to-crank-arm bolt torque is 33-37 ft-lbs

2 - See Fig. 1 for location of indicator in the 4iiii App. Replace batteries when low.

3 - Excessive side-to-side movement or bearing resistance indicates the pedals need to be replaced.

4 - Use water with a non-abrasive soap, car wash soap, or bike cleaner soap to clean. Wipe with water and dry. Seal with wax or bike polish.

5 - Dry film lubricant with PTFE or wet film lubricant with PTFE may be used. These products can be purchased online via pike companies, at bike shops, and at some hard-

ware stores. Apply a layer using a cloth to clean up excess.

6 - Wipe console with a soft, non-abrasive cloth to remove all sweat after each use. Use a soft, non-abrasive cloth and mild spray cleanser to clean the console. Never use

abrasive cleaning liquids, cleaning liquids with an oil base, ammonia, or alcohol.

Preventive Maintenance Cautions

•

While maintaining equipment you will want to avoid spraying any

liquids directly onto any surface of the unit. Always spray cleaning

solutions onto a clean towel first then wipe the unit.

•

Do not use glass cleaners or any other household cleaners on the

console. The console should be cleaned with a damp cloth and dried

on a daily basis. Cleaning solutions can be made of a 5:1 dilution ratio,

where 5 parts water are mixed with 1 part of Simple Green®, Fan-

tastik®, or 409®. Do not spray water, or cleaner directly onto console