Epson DX5 X 2 Calibration And Maintenance page 16

Repeat the test until the "0" is facing each other perfectly.
5. Step offset
The Step offset locates on Option
To adjust the step offset, firstly adjust the
automatically. And slightly adjustment is needed according to actual printing.
Based on the "0" position, input the value which two line are perfectly overlapped. After input the value, test
again to check the result. The step value will be different according to different media.
Note: Note: Turn Turn off off the the Eclosion Eclosion
Note: Note: Turn Turn off off the the Eclosion Eclosion (Feather)
step step step step value. value. value. Then value. Then Then Then test test test print test
function function to to to to reach reach your
function function reach your reach your best your
Option Option Calibration Calibration
Option – Calibration Calibration – Step
Input the offset
value
Base Step, Base Base Base
Have to input
+2.
(Feather) (Feather) function function
(Feather) function function first
print print to to to to see print see see whether see whether whether there whether
best image quality.
best best image image image quality. quality. quality.
The The The The adjustment adjustment adjustment of of of of software adjustment
Step Step Offset Offset
Step Offset Offset
Step, Step, Step, then the value of other pass will be calculated
first first while while adjusting adjusting
first while while adjusting adjusting the
there there is is is is banding there banding banding banding on on on on the the
software software software has has has has been been been completed been
16
the the step step offset. offset.
the step step offset. offset. Adjust
the the image. image. image. image. If If If If so, so, so, use so, use the use use
completed completed completed now now now now
Adjust Adjust to to to to get Adjust get get the the best best
get the the best best
the Eclosion the the Eclosion Eclosion Eclosion (Feather) (Feather) (Feather) (Feather)