Epson DX5 X 2 Calibration And Maintenance page 11

Case 3：two printhead facing each other perfectly, no need to adjust
st
1 printhead
status
nd
2 printhead
status
2. Vertical calibration: Observe the physical alignment of printheads
（If If If If this
this this step this step is is is is not step step not not not aligned aligned aligned aligned well
.
The procedure to adjust vertical calibration in two printhead:
1) Follow the following step to adjust 1
st
is 1 printhead)
2)Then follow the following step to adjust 2
printhead)
3)After finish both printhead vertical alignment, adjust 2
between two printhead. Space between two printhead is 1 nozzle, print the printhead status to confirm.
There are 2 screws for adjust 2
st
1 printhead vertical
alignments adjust here
well which well well which which will which will will affect will affect affect affect the
st
printhead vertical alignment individually (Face carriage, the left one
nd
printhead vertical alignment (Face carriage, the right one is 2
nd
printhead vertically and horizontally:
1st printhead
nd
2
alignment adjust here
the the the following following adjustment following following adjustment） adjustment adjustment
nd
printhead horizontal position to change the space
nd
2 printhead
printhead vertical
11
Two printhead
face each other in
straight vertical
position
st