Primary Ide Master/Slave - Asus M2N68 Manual

2.3.4 Storage Configuration
The items in this menu allow you to set or change the configurations for the IDE or
Serial-ATA devices installed in the system. Select an item then press <Enter> if you
wish to configure the item.
Storage Configuration
Onboard IDE Controller
Serial-ATA Devices
SATA Mode select
Onboard IDE Controller [Enabled]
Allows you to enable or disable the onboard IDE controller.
Configuration options: [Disabled] [Enabled]
Serial-ATA Devices [Enabled]
Allows you to enable or disable the serial-ATA devices.
Configuration options: [Disabled] [Enabled]
SATA Mode select [SATA Mode]
Configuration options: [SATA Mode] [RAID Mode] [AHCI Mode]
2.3.5

Primary IDE Master/Slave

While entering Setup, the BIOS automatically detects the presence of IDE devices.
There is a separate sub-menu for each IDE device. Select a device item then
press <Enter> to display the IDE device information.
Primary IDE Master
Device
Vendor
Size
LBA Mode
Block Mode
PIO Mode
Async DMA
Ultra DMA
SMART Monitoring: Supported
Type
LBA/Large Mode
Block(Multi-Sector Transfer) M
PIO Mode
DMA Mode
SMART Monitoring
32Bit Data Transfer
2-16
[Enabled]
[Enabled]
[SATA Mode]
: Hard Disk
: ST320413A
: 20.0GB
: Supported
: 16 Sectors
: Supported
: MultiWord DMA-2
: Ultra DMA-5
Disabled: disables
the integrated IDE
Controller.
Enabled: enable
the integrated IDE
Controller.
Exit
[Auto]
[Auto]
[Auto]
[Auto]
[Auto]
[Auto]
[Enabled]
Select the type
of device connected
to the system.
Chapter 2: BIOS setup