ISSUE 1.0
1.5.5
Cable Routing and Clamping
1.
Depending on cabling requirement, select either a right or left route. Clamp and route cable to
outside.
2.
Cut and remove the Plastic Knockouts as needed from the Sub-Cover.
3.
Replace the Sub-Cover.
Hardware Manual
Table 2-4 RJ61 Cable Connector Pin-Outs (J101-J103)
Pin No.
ESI 1-4 (J101), ESI 5-8 (J102):
2-Wire Digital Extension Port
1
2
3
4
5
6
7
8
Figure 2-14 Cabling
Figure 2-15 Sub-Cover
Connector (RJ-61)
T4 (Tip for port 4)
T3 (Tip for port 3)
T2 (Tip for port 2)
R1 (Ring for port 1)
T1 (Tip for port 1)
R2 (Ring for port 2)
R3 (Ring for port 3)
R4 (Ring for port 4)
SL1100
SLI 9-12/DPH 1-2 (J103):
Analogue Extension Port
Connector (RJ-61)
T4 (Tip for port 4)
T3 (Tip for port 3)
T2 (Tip for port 2)
R1 (Ring for port 1)
T1 (Tip for port 1)
R2 (Ring for port 2)
R3 (Ring for port 3)
R4 (Ring for port 4)
2-11