2.14 General Purpose/Door Unlock Relay Specifications; 2.15 External Paging Output Specifications; 2.16 Bgm/Exmoh Source Input Specifications; 2.17 External Sensor Device Interface Specifications - NEC SL1100 Hardware Manual

ISSUE 1.0

2.14 General Purpose/Door Unlock Relay Specifications

Table 5-10 General Purpose/Door Unlock Relay Specifications

Item
Rated Voltage
Rated Current
Contact

2.15 External Paging Output Specifications

Item
Output Impedance
Output Level
Maximum Output

2.16 BGM/ExMOH Source Input Specifications

Table 5-12 BGM/External MOH Source Input Specifications

Item
Output Impedance
Input Level
Maximum Input

2.17 External Sensor Device Interface Specifications

Table 5-13 External Sensor Device Interface Specifications

Applied Voltage during
Sensor Off
24 V
5 V
The External Sensor device configuration shall be assigned by system program and the programming
is different with a Sensor Type.

2.18 CPU Card LAN Port Specifications

Item
Standard
Access
I/F (Layer 1)

2.19 Cabling Requirements

Do not run extension cable in parallel with the AC source, telex or computer etc. If the cables are

near cable runs to those devices, use shielded cable with grounded shields or install the cable in
conduit.
When cables must be run on the floor, cable protectors must be used.

Cable runs for Multiline Telephones, DSS Consoles, Single Line Telephones, and Doorphone

Boxes must be a dedicated, isolated cable pair.
Aerial distribution cabling is not allowed.

Trunk Lines must be installed with lightning protectors.

Do not use 4-wire cabling for SLT connections.

Hardware Manual

Table 5-11 External Paging Output Specifications

Loop Current during
Sensor On
40 mA

Table 5-14 CPU Card LAN Port Specifications

IEEE802.3 10Base-T and 100Base-TX Compliant
CSMA/CD
Speed: 10 Mbps/100 Mbps Auto Negotiation
Cable: CAT5 or better, Straight/Cross Auto Crossover
Specification
DC 48 V Maximum
DC 320 mA Maximum
Normally Open
Specification
600 Ω @ 1 kHz
Nominal 250 mV (-10 dBm)
400 mV RMS
Specification
600 Ω @ 1 kHz
Nominal 250 mV (-10 dBm)
1 V RMS
Specification
SL1100
Port Assignment
Program10-03-05: 0
Program10-03-05: 1
5-5