How Do I Replace The Attachments Of My Philips Groomer?; Click-On Cutting Element; Cutting Units With Legs; Combs With Legs - Philips Norelco Beardtrimmer 3000 Frequently Asked Questions Manual

4. How do I replace the attachments of my Philips Groomer?

Your Philips Groomers, Hair Clippers and Beard Trimmers may come with a lot of different
attachments. Find out here how to replace and use these attachments.

Click-on cutting element

The cutting element is the main unit of your Philips Groomer. It has short, sharp edges and is used to
give you a fast and clean trim.
To remove the cutting unit from the body of your groomer, check if there is a release button on the
body of your groomer. If yes, press the button to detach the unit.
If the groomer does not have a release button, then place a finger under the teeth of the cutting unit
and pull it upwards to take it off. To reattach it, first insert its bottom part in the body of the groomer
and then push in the teeth part until you hear a click. Do not force the attachment in, as this may
damage the device.
If you are having difficulty attaching it, check if there is something stuck inside the body, and try
cleaning it with a small brush or cotton bud.

Cutting units with legs

Some cutting units have long legs on the side. To remove these type of attachments, hold them from
both sides and pull them off the appliance. To reattach them, push them back in the slot, until you
hear a click.

Combs with legs

Trimming combs can be added on top of the cutting unit of your Philips Groomer. These can be used
to clip the hair on your head or trim your beard to a certain length.
Removing these types of combs is easy. Just pull them off the body of your groomer. To attach the
comb gently slide it down on top of your cutting element, so that the legs fit in the designated slots
at the side.