Sync An Add-On Satellite; Log In To Your Router And Add A Satellite To Your Network - NETGEAR LBR20 User Manual

Sync an add-on satellite

If you already set up the router and are adding an optional add-on satellite (sold
separately), follow these steps.
To sync your add-on satellite:
1. Place your satellite.
Make sure that your satellite is within range of your router's WiFi signal.
2. Connect the satellite to a power source.
3. If the Power LED on the back of the satellite does not light and if satellite has a Power
On/Off button, press the Power On/Off button.
4. Wait about two minutes for the satellite ring LED to light solid white.
5. Press the Sync button on the back of the satellite and within two minutes, press the
Sync button on the back of your router.
The satellite ring LED pulses white, then lights one of the following colors for about
three minutes, and then turns off:
• Blue. The router and satellite successfully synced, and the connection between
the router and satellite is good.
• Amber. The router and satellite successfully synced, and the connection between
the router and satellite is fair. Consider moving the satellite closer to the router.
• Magenta. The router and satellite failed to sync. Move the satellite closer to the
router and try again.
Log in to your router and add a satellite to
your network
You can use the router web interface to add a satellite to your Orbi network.
To add a satellite to your Orbi network using the router web interface:
1. Launch a web browser from a computer or mobile device that is connected to your
Orbi network.
2. Enter orbilogin.com.
A login window opens.
3. Enter the router admin user name and password.
Set Up and Manage an Optional
Orbi Satellite
4G LTE WiFi Orbi Router Model LBR20
133 User Manual