1111 W. 35th Street Chicago, IL 60609 USA
Customer Support: (773) 869-1234
www.tripplite.com
PowerVerter
IMPORTANT SAFETY INSTRUCTIONS. This addendum and the accompanying
manual contain information concerning the proper installation of Tripp Lite
equipment. SAVE THESE INSTRUCTIONS.
Your PowerVerter is identical to the Inverter/Charger described in the accompanying owner's manual with
the two exceptions (Hardwire Connection and Dip Switch Settings) described here.
Hardwire AC Connection
Warning! Consult a qualified electrician and follow all applicable electrical
codes and requirements for hardwire connection. Disconnect DC input and
AC utility supply before attempting hardwiring.
Connection for Models with Hardwire Terminals
Remove the screws and cover plate over the hardwire terminal box. Remove the knockout covers closest to
the desired electrical source and to your equipment. Attach ½" diameter conduits (user-supplied) to the
knockouts and thread wires through. Connect the conduits to each other with the ground bond connection
supplied.
Ground
• Connect the incoming and outgoing ground
wires to the GROUND (green) terminal.
AC Input
• Connect the incoming hot wire to the input hot
(brown) terminal.
• Connect the incoming neutral wire to the input
neutral (blue) terminal.
AC Output
• Connect the outgoing hot wire to the output
hot (black) terminal.
• Connect the outgoing neutral wire to the
output neutral (white) terminal.
Tighten and affix strain relief. Replace cover plate and tighten screws.
Hardwired Electrical Connections
®
& Dip Switch Settings
Power Inverters (120V, 60 Hz)
2
3
4
5
Owner's Manual
Addendum
1
2
3
1
4
5
"FOR USE WITH COPPER WIRE ONLY"
HOT
IN
NEUTRAL
IN
GROUND
IN
GROUND
OUT
HOT
OUT
NEUTRAL
OUT