Tripp Lite BP240V10RT-3U Owner's Manual page 18

Power ON/OFF (5kVA models only)
1. Configure your UPS's input and output: Put your UPS power module into setup mode by holding down both of its scroll buttons (
and B ) at once. Scroll through the setup options (using
the "SELECT" button B .
• Input & Output Voltage: Select 200, 208 or 240 VAC.
• Output Frequency: Your UPS will autoselect 50 or 60 Hz to match the input.
• Economy Mode: Your UPS can provide on-line operation with zero transfer time. It can also operate in a more energy-efficient
line-interactive mode. Select Economy On to put the UPS in line-interactive mode. Select Economy Off to put the UPS in on-line mode.
• After you have set these options, "exit" the setup mode with the scroll button
button C down until you hear a beep.
2. Turn input to the UPS ON: Press and hold the power module's ON button
mode. Note that some electronic equipment may draw more amps during startup; when starting from battery, consider reducing the ini-
tial load on the UPS. Your UPS will perform a brief self-test and show the results on the LCD Display
"Operation" section for the display sequence.
3. To turn the UPS power module and transformer module (if used) OFF: Press the power module's OFF button
beep. Your load will still be energized. The inverter is now off, but your UPS is not fully deactivated. The LCD Display
BYPASS MODE. Turn the power module's Output Breaker
a transformer module is used, unplug its connector cable from the power module. Your load will no longer be energized, and the LCD
Display D will be dark.
A or B ) and select the appropriate setting for each of the following options using
OFF. Unplug the power module's AC input cord from the wall outlet. If
E
E
5kVA Models
, then exit bypass mode by holding the ON
A
C until you hear a beep to start your UPS in ON BATTERY
18
D . See "Startup Self-Test" in the
F until you hear a
D
D
C A B F
5kVA Models
(Front Panel)
A
will show