Table of Contents
Advertisement
selecting
Network
Access Services
Next, the
8
presented, and then the
Select the entry labeled
8-a
Click the
8-b
On the
8-c
and click
Click
8-d
Click
8-e
Exit the Network Control Panel by clicking
8-f
When prompted to, restart the system.
8-g
If you have more than one client connection, repeat the following
procedure for each client:
Click the
8-h
Double-click the
8-i
Select
8-j
Properties
Click the
8-k
to add your additional client connection. Click
Repeat steps
8-l
NOTE: Microsoft recommends that you re-install the latest Service
Pack for your system after installing RAS. Refer to instructions in
the Release Notes for installing the latest service pack.
When the system comes back up, one or more configuration dialog
9
boxes may or may not be presented, depending on your service
provider. Configure the settings as directed by your network service
provider.
Efficient Networks, Inc.
; click on
Settings
icon and then click
from the list and click
Remote Access Services
Add RAS Device
Configure
Configure Port Usage
.
OK
and make sure
Network
when all configuration is complete.
Continue
button and select
Start
Network
Remote Access Services
button.
button in the
Add
through
8-b
Control Panel
Services
configuration dialog box is
dialog box appears.
ISDN_n ENx0P
button.
dialog box, select
TCP/IP
Settings
icon and click the
from the list and click the
Remote Access Setup
above.
8-g
. Double-click on the
and
. Select
Add
.
OK
and click
.
OK
Dial Out Only
is checked. Click
.
Close
; click
Control Panel.
Services
dialog box
.
OK
Installing PPP Software
Remote
.
OK
tab.
21
Advertisement
Table of Contents
