Table of Contents
Advertisement
When the system comes back up, one or more configuration dialog
7
boxes may or may not be presented, depending on your service
provider. Configure the settings as directed by your network service
provider. When configuration is complete, if prompted to restart
Windows, click
When the system comes back up, you will need to set up your PPP
8
dial-up connection as described on page 22.
Troubleshooting Windows 95
Installation
Recovery from Canceling Installation
An incomplete installation may occur if:
In Windows 95 or 95A, if you select
•
Hardware Found
In Windows 95B, if you click
•
dialog box without inserting the SpeedStream installation CD
Wizard
Use the following procedure to clear the partial install from the system.
Click
1
Start
Double-click
ENI card under "*
Click
2
Remove
Shut down and restart the system; then perform the software
3
installation procedure again.
PPP Driver Installation without Dial-Up Networking
If the drivers are installed on a system that does not have the latest version
of DUN installed, the installation procedure describes what will occur. If
the system is not restarted as required during DUN installation, the
installation software will not be able to create address book entries. To
recover from this situation, use the following procedure to update the
service profile:
Efficient Networks, Inc.
.
Yes
dialog box
and point to
Settings
and click the
System
Other devices
. Exit the Device Manager and reboot the machine.
Do not install a driver
on the
Finish
Update Device Driver
; then click
Device Manager
".
on the
.
Control Panel
tab. Select the
Installing PPP Software
New
15
Advertisement
Table of Contents
