Accessories - RIDGID R32104 Operator's Manual

MAINTENANCE
BRUSH REPLACEMENT
See Figure 26, page 17.
The tool has externally accessible brush assemblies that
should be periodically checked for wear.
 Unplug the tool.
 Remove the brush cap by turning it counterclockwise.
The brush assembly is spring loaded and will pop out
when you remove the brush cap.

ACCESSORIES

Look for these accessories where you purchased this product:
 Edge Guide ...................................................................................................................................................... 690119004
 Edge Guide Knob ............................................................................................................................................ 511129001
WARNING:
Current attachments and accessories available for use with this tool are listed above. Do not use any attachments
or accessories not recommended by the manufacturer of this tool. The use of attachments or accessories not
recommended can result in serious personal injury.
NOTE: ILLUSTRATIONS START ON PAGE 15 AFTER
This product has a 90-Day Satisfaction Guarantee Policy,
as well as a Three-year Limited Warranty. For Warranty and Policy details,
please go to www.RIDGID.com or call (toll free) 1-866-539-1710.
FRENCH AND SPANISH LANGUAGE SECTIONS.
 Remove the brush assembly (brush and spring).
 Check for wear. If worn, always replace in pairs. Do not
replace one side without replacing the other.
 Replace the brush cap and tighten securely.
14 - English