Fitting The Hob (Ventilation, Furniture Requirements Etc.) - CDA HN6732FR Installation, Use And Maintenance Manual

Fitting the hob
Unpacking the hob:
Take care not to lose, drop or
mishandle any parts.
Fitting position of the hob:
This appliance must be, when installed,
a minimum of 50mm from any back
wall and a minimum of 180mm away
from any adjacent vertical surfaces, e.g.
a tall cupboard end panel. This may
be reduced to 100mm if the adjacent
surface is resistant to fire (tiles or steel
for example). These dimensions are
shown in Fig.8 on page 27.
Ventilation requirements:
This appliance must be installed to
allow air to flow freely to the air intake
and from the air outlet. An air gap of
25mm+ is recommended immediately
below the hob.
Failure to allow sufficient ventilation
could cause problems with operation
or damage to the hob and constitutes
incorrect installation, which is not
covered by the product's warranty
(Figs. 4 and 5).
24
Installation above a cupboard unit
25mm
30mm
Installing hob in kitchen cabinet
worktop.
Fig. 4
Installation above an oven unit
500x20mm
Installing hob in kitchen worktop
above oven with ventilation.
Fig. 5
500x10mm
5 10mm
÷
5 10mm
÷