Remington Hyperflex Verso Manual page 5

ENGLISH
• The adaptor automatically adjusts to a mains voltage between 100V and
240V.
• This appliance should be charged by approved safety isolating adaptors
PA-0510E(K) with the output capacity of 5.0 dc; 1.0A.
F INSTRUCTIONS FOR USE
, SHAVING
, Note: This shaver is for cordless use only.
• Make sure your shaver is properly charged.
• Switch the shaver on.
• Stretch the skin with your free hand so the hairs stand upright.
• Only apply light pressure on the shaving head while shaving (pressing too
hard can damage the heads and make them vulnerable to breakage).
• Use short, circular strokes.
, SHAVING WITH SHAVING GEL
• Follow the same instructions as dry shaving if using shaving gel.
, CAUTION
• After use with shaving gel, please rinse the head and cutters under warm
water to clean away any excess gel and debris.
, TRIMMING
• Push the trimmer button to release the detail trimmer.
• Hold the trimmer at a right angle to your skin.
• Place the trimmer at desired trim line for a quick, easy, professional trim.
• To retract the trimmer, push down until it locks into position.
E Tips for best results
• Use moderate to slow stroking movements. The use of short circular
motions in stubborn areas may obtain a closer shave, especially along the
neck and chin line.
• DO NOT press hard against the skin in order to avoid damage to the rotary
heads.
, CHANGING SHAVE / GROOMING HEADS
• The shaver should be switched off when changing heads.
• Grasp the shave head at the blue collar and pull up to unsnap the head
from the handle.
• Attach the interchangeable heads to the handle by aligning the hexagon
shapes of the head to the handle, then pressing together to snap in place.
5