SIDE GEARBOX
1. Remove the vent plug on the top of the side gearbox and the small inspection plug at the side of the
gearbox.
2. Pour the gear oil into the vent plug hole slowly until the oil starts to come out of the small hole on the side.
DO NOT OVERFILL THE GEARBOX!
3. Replace the small Inspection Plug and the Vent Plug. Clean up any excess gear oil.
OUTBOARD BEARING
Use 90W Gear Oil in the Outboard
Bearing located on the right hand
side of the tiller. Fill until 1/2 to 3/4
full to allow for oil expansion.
RTXG SERIES TILLER 5/19
© 2020 Alamo Group Inc.
ASSEMBLY
Assembly Section 3-6