Advertisement
(Figure 11. Touch Screen Left Side Screw Locations)
c) Prior to installing the new touch screen, be sure to remove the clear
protective backing installed on the inside of the screen (if applicable).
Do not allow fingerprints to contaminate the inside face of the touch
screen!
d) Install the new touch screen, and follow the removal steps in reverse;
route the ribbon cable through the slot first, then seat the touch screen.
e) Ensure the ribbon cable connector is installed with the exposed etch
side face-down, and the pull tab facing inwards when plugged into the
connector receptacle as shown in figures 8 and 9.
f) Be aware that both top corners of the touch screen have (black) guide
pins to align the touch screen on its mounting bracket. See figure 9
for details. Do not over-torque the mounting screws.
Advertisement
