AS-9400
User Guide
Command Barcode
Scanning the Enter Setup Code can enable the engine to enter the setup mode. Then you can
scan a number of command codes to configure your scanner. To exit the setup mode, scan the
Exit Setup code.
Enter Configuration
Exit Configuration
Important Notes:
All configurations need to go through below steps except Factory Defaults.
Scan "Enter Setup" → "Command Barcode" →"Exit Setup"
Restore Factory Default Configuration
Restore Factory Default Configuration
Enable All Symbologies
If Enable All Symbologies feature is enabled, the scanner will be able to read all 1D and 2D
barcodes except the command barcodes.
Enable All Symbologies
Enter Configuration
Exit Configuration
- 1 -