Table of Contents
Advertisement
4
Using both hands, gently tilt the top of the door
glass towards you, lift slightly to disengage the
locators from the two bottom brackets.
5
Clean the outer and inner glass using hot soapy
water or Hob Brite cleaner may be used. DO
NOT try to clean the aluminium foil which is
inside the door. The foil is there to help keep the
door cool, if it is damaged it will not work. Ensure
that all parts are well rinsed and thoroughly dried
before attempting to replace the outer door.
TO REPLACE THE OUTER GLASS
1
Holding the oven glass with both hands, gently
place the locators into the holes of the brackets
at the bottom of the oven door.
2
Push the top of the oven glass towards the oven
door, ensuring the screw location holes line up.
3
Hold the glass in place with one hand and insert
the cross head screws into the location holes
with the other hand. Give the screws one turn to
ensure the glass is secure.
4
Tighten the screws positively with a Pozidrive
screwdriver before closing the oven door.
5
Do not attempt to use the oven without the glass
being in place.
If the door glass panel becomes chipped or has
deep scratches the glass will be weakened and
must be replaced to prevent the possibility of
the panel shattering. Please contact your local
Service Centre who will be pleased to advise
further.
TO CLEAN THE INNER GLASS DOOR
PANELS
Clean the inner glass door panels using a soft cloth
and hot water to which a little washing up liquid has
been added. If the inner panel is heavily soiled, Hob
Brite may be used. Do not use abrasive cleaning
materials on the door glass. Ensure that all parts are
well rinsed and thoroughly dried before attempting to
replace the glass.
28
REPLACING THE OVEN LIGHT BULB
The type of bulb required is a 300°C 25 watt small
Edison Screw.
Part number 572 491 5431-00/1
(Available through Tricity Bendix Service Centres).
CAUTION:
Disconnect the appliance from the
electricity supply before replacing the bulb.
Open the door and remove the shelves to enable
easy access to the oven light assembly. Insert a flat
blade screwdriver between the oven side and glass
which covers the bulb.
Support the glass with your hand and prise out
sufficiently to release the glass cover. Unscrew the
bulb in an anticlockwise direction until it is possible to
remove the bulb with ease.
Fit the new bulb by turning in a clockwise direction
until it is secure. Ensuring the indent to the flange is
pointing to the rear of the oven, replace the glass by
pushing it firmly into the hole to cover the bulb
assembly.
Replace the shelves. Restore the electricity supply
and adjust the time of day and clock as necessary.
Advertisement
Table of Contents
