Installing Wire Guide And Drive Roll - Miller ST-24w Owner's Manual

4-7. Installing Wire Guide And Drive Roll

2
3
Tools Needed:
1/4 in.
1
4
1 Inlet Wire Guide Securing
Screw
2 Inlet Wire Guide
Loosen screw. Slide tip as close to
drive rolls as possible without
touching. Tighten screw.
3 Drive Roll
The drive roll consists of two differ-
ent sized grooves. The stamped
markings on the end surface of the
drive roll refers to the groove on the
opposite side of the drive roll. The
groove closest to the motor shaft is
the proper groove to thread.
4 Drive Roll Securing Nut
Turn nut one click to secure drive
roll.
5 Euro-Adapter Securing Screw
5
OM-287388 Page 13
956142644_1-B