Section 5 − Installation; Installing Wire Guide And Drive Roll; Plug Connections; Remote Receptacle Rc2 Information - Miller SUBARC WIRE DRIVE 400 T CE Owner's Manual

5-1. Installing Wire Guide And Drive Roll

.
Motor shown without feed roller guard.
Tools Needed:
1/4 in.

5-2. Plug Connections

2

5-3. Remote Receptacle RC2 Information

REMOTE 10
Wirefeed Drive
Motor Hookups
OM-253789 Page 12
SECTION 5 − INSTALLATION
6
5
4
3
2
1
3
.
Motor shown without feed roller guard.
Socket
A Negative (−) motor armature (38 VDC motor).
B Encoder common and motor identification (resistor across H and B).
C Shield drain leads.
F Positive volt sense.
H Motor identification (resistor across H and B).
I Encoder VCC (+5 VDC).
J Positive (+) motor armature (38 VDC motor).
K Encoder channel A.
.
When changing wire size or type,
check drive roll size
(see Table 5-1).
1 Wire Pressure Adjustment Screw
Loosen screw to decrease tension on
spring.
2 Drive Roll Nut
3 Drive Roll (Not Supplied)
Remove drive roll.
4 Drive Roll Carrier
Turn nut one click to line up lobes with
lobes on drive roll carrier.
5 Wire Guide Securing Screw (Hidden)
Loosen wire guide screw.
6 Inlet Wire Guide (Supplied With Wire
Straightener Kit)
Remove inlet wire guide.
Install drive rolls, and turn drive roll nut one
1
click.
1 Subarc Interface (Digital
Shown)
2 Motor Control Cord Part No.
254232XXX
XXX indicates cable length.
3 Wire Drive
To make connections, align key-
way, insert plug, and tighten
threaded collar.
Socket Information
Ref. 265710-A
265711-A