Electrolux Silent Performer Cyclonic EL4021A Service Manual page 14

Reset
If the receiver has saved transmitter address – New transmitter / New bentend
1. Plug in the cord to the main. Do not turn on.
2. Send Reset signal - 1+4 button combination at the same time (to do this you have 20s after
connection to main ) ) If the cleaner received the right reset signal it will fluctuate.
3. Unplug the cord from the main.
4. Wait min 5sec.
5. Plug in the cord to the main again. The cleaner should fluctuate.
6. Send teaching signal - 1+3 button combination at the same time (to do this you have 20s after
connection to main )
7. If the teaching was successful the cleaner will turn on (1.5s) and after that turns off.
8. The cleaner is ready to use.
EN Publication number Rev. 01 09/2015 PR - 14/17