Cisco Nexus 3400 Series Hardware Installation Manual page 33

Installing the Chassis
Step 5 Insert the rack-mount retainer brackets
a) Align the retainer brackets to the front of the chassis, being careful not to damage anything on the front of the chassis
(see the following figure).
b) Repeat Step 5 to attach the other retainer bracket on other side of the chassis.
c) Tighten the 10-32 screws to 20 in-lb (2.26 N·m) or tighten the 12-24 screws to 30 in-lb (3.39 N·m).
Step 6 Insert the retainer clip to hold the chassis in place.
a) Align the retainer clip to the inside of the back of the slider rail. Make sure to hook the flange to the cutout on the
bracket and align the screw holes (see the following figure).
b) Attach the screws to secure the retainer clip (see the following figure).
c) Repeat Step 6 to attach the other retainer clip on the other side of the chassis.
Installing the Switch using the NXK-ACC-RMK-2RU Rack-mount Kit
Cisco Nexus 3400 Hardware Installation Guide
25