Unpacking And Inspecting The Chassis - Cisco Nexus 3400 Series Hardware Installation Manual

Unpacking and Inspecting the Chassis

• You have the following equipment in addition to the switch and the kits shipped with the switch:
Unpacking and Inspecting the Chassis
Caution When handling switch components, such as fan or power supply modules, wear a grounded ESD strap and
handle the modules by their carrier edges only. To ground the ESD strap, make sure that it is attached to an
earth ground, a grounded chassis, or a grounded rack.
Tip Keep the shipping container in case the chassis requires shipping in the future.
Cisco Nexus 3400 Hardware Installation Guide
10
Warning
Statement 1005 Circuit Breaker
When AC or HVAC power supply is used:
This product relies on the building's installation for short-circuit (overcurrent)
protection. Ensure that the protective devices is rated not greater than 20A (North
America), 16A (Europe), and 13A (UK).
When HVDC power supply is used:
This product relies on the building's installation for short-circuit (overcurrent)
protection. Ensure that the protective devices is rated not greater than 10A.
• There is adequate clearance around the rack to install the switch and to allow for unimpeded airflow.
• Eight customer-supplied 12-24 or 10-32 screws (required for attaching slider rails and mounting
bracket to the mounting rails)
• Number 1 and number 2 Phillips screwdrivers with torque capability
• 3/16-inch flat-blade screwdriver
• Tape measure and level
• ESD wrist strap or other grounding device (wrist strap can be found in the accessory kit)
• Antistatic surface large enough to place the switch
• Grounding cable (6 AWG recommended), sized according to local and national installation
requirements; the required length depends on the proximity of the switch to proper grounding
facilities
• Crimping tool large enough to accommodate the girth of the grounding lug
• Wire stripping tool
Installing the Chassis