Maintenance Every 2000 Hours Of Operation; Changing The Oil In The Hydraulic Tank And Cleaning The Filter; Tenance Every 500 Hours Of Operation") A. Changing The Oil In The Hydraulic Tank And Cleaning The Filter - Komatsu PC18MR-3 Operation & Maintenance Manual

MAINTENANCE PROCEDURES

4.9.9 MAINTENANCE EVERY 2000 HOURS OF OPERATION

Carry out these operations together with those to be performed every 500 HOURS and every 1000 HOURS.
4.9.9.a

CHANGING THE OIL IN THE HYDRAULIC TANK AND CLEANING THE FILTER

To carry out this maintenance operation it is necessary to tilt the cab floor. Carefully follow the instruc-
q
tions given in paragraph "3.2.9 TILTING THE CAB FLOOR" or have this operation carried out by your Ko-
matsu Distributor.
Retract the arm and bucket cylinders completely, rest the bucket teeth on the ground and, after stopping
q
the engine, eliminate the residual pressures from the equipment (by shifting the controls more than
once) and from the tank (by slowly loosening the filler cap).
Soon after the machine has been stopped, the hydraulic oil is very hot and may cause burns; let it cool
q
down to 40÷45° C before carrying out this maintenance operation.
Immediately clean any area dirty with oil.
q
Oils, filters, the coolant and the battery are considered special waste and must be collected and dis-
q
posed of according to the regulations in force.
On machines containing synthetic biodegradable hydraulic oil type HEES, this must be changed after
q
the first 500 hours of operation and successively every 2000 hours, and in any case at least once a year.
IMPORTANT
If the machine is equipped with demolition hammer, the hydraulic oil deteriorates much earlier than dur-
q
ing normal bucket operations. For further details on maintenance, see "4.8.2 MAINTENANCE INTER-
VALS IN CASE OF USE OF THE HYDRAULIC BREAKER".
1. Turn the revolving frame so that the lower part of the hydrau-
lic oil tank is not covered by the tracks.
2. Retract the arm and bucket cylinders completely and lower
the boom until the bucket teeth rest on the ground.
3. Lower the blade to the ground.
4. Stop the engine and eliminate the residual pressure from the
work equipment (by shifting the controls more than once).
244
WARNING
CAUTION
RKA23090
WEAM012101