Table of Contents
Advertisement
Fixing Installation Plate
The wall you select should be strong and solid
enough to prevent vibration
1
Mount the installation plate on the wall
with type "A" screws. If mounting the unit
on a concrete wall, use anchor bolts.
- Mount the installation plate horizontally
by aligning the centerline using Horizontal
meter.
2
Measure the wall and mark the centerline.
It is also important to use caution
concerning the location of the installation
plate. Routing of the wiring to power
outlets is through the walls typically.
Drilling the hole through the wall for piping
connections must be done safely.
Place a level on raised tab
Unit Outline
418
Ø 65
Installation Plate
98
152
Unit Outline
Drill a Hole in the Wall
- Drill the piping hole with a ø 65 mm hole
core drill. Drill the piping hole at either the
right or the left with the hole slightly slanted
to the outdoor side.
418
Ø 65
134
194
(Unit : mm)
INSTALLATION
Place a level on raised tab
494
Ø 65
Measuring
Tape
83
134
Measuring Tape
Hanger
WALL
Indoor
17
504
Ø 65
83
150
(Unit : mm)
Outdoor
Advertisement
Table of Contents
