2.2 Easy Installation
12
C/KU Switch:
You can select C/KU band by selection of switch type.
(None, DiSEqC Switch)
Position (DiSeqC 1.2)
After selecting a satellite, please select position number.
To change value, press the
The position list will be displayed.
LNB Freq.
Select the proper LNB frequency referring to your LNB using the
the
UP/DOWN
buttons.
C-LNB Freq.
When selecting the C/KU Switch is selected as "None", the C-LNB Freq
will be dimmed automatically.
Press the
OK
button, and then the C-LNB Freq. list will be displayed.
You can also input the freq. you want. After inputting freq.
Using the
NUMERIC
buttons, press the
(None, DiSEqC Switch)
LNB Power
Select the LNB Power On or OFF.
22KHz
Depending on the user's antenna switch box or LNB. You can supply
either 22KHz by setting "ON" or not by setting "OFF".
Tone Burst
Depending on the user's antenna switch box. ("off", "SAT A" or "SAT B")
DiSEqC - DiSEqC
You can select and use appropriate port for your DiSEqC switch box.
Press the
OK
button to select DiSEqC List. (None, DiSEqC A, DiSEqC B,
DiSEqC C, DiSEqC D, Motor, USALS)
DiSEqC - DiSEqC 1.2 and USALS
Press the
BLUE
button to set Drive(Fine Drive or Normal Drive) to run
the motor.
•
Fine Drive/Normal Drive
To move the motor, press the
•
Go to zero
To move the zero position, press the
•
Store to location
To store the current position, press the
•
East Limit
To set the east limit by current position, press the
•
West Limit
To set the west limit by current position, press the
•
Clear Limit
To clear the stored limit value, press the
OK
button.
OK
button.
LEFT/RIGHT
button.
OK
button.
OK
button.
OK
button.
OK
and
OK
button.
OK
button.